Enterprise Connection Division: The Power to Connect

NIPRNET

PRINT PAGE Add This

NIPRNet Connection Process

Follow steps in the appropriate Partner Profile section of this guide.

Process Deviations and/or Additional Requirements

There are no additional requirements and/or process deviations.

NIPRNet Connection Process Checklist

This checklist provides the key activities that must be performed by the Partner/sponsor during the NIPRNet connection approval process.

ItemDoD Partner Non-DoD Partner
NewExistingNewExisting

Obtain OSD approval for Non-DoD connection

 

 

5

Provision the connection

 

5

Perform the C&A process

Obtain an accreditation decision (ATO/IATO/IATT)

Register the connection

6

5

Register in the SNAP database

6

5

Register in the PPSM database

6

5

Register in the DITPR database

6

5

Complete the CAP Package

DIACAP Executive Package (or equivalent for Non-DoD entities)

DIACAP Scorecard

System Identification Profile

Plan of Actions and Milestones, if applicable

DAA Appointment Letter

Network/Enclave Topology Diagram

Consent to Monitor

Proof of Contract

 

 

DOD CIO Approval Letter

 

 

Submit the CAP Package to the CAO

Receive NIPRNet ATC/IATC

5 This step is not required for reaccreditation Non-DoD Partner connections unless there has been a change in Sponsor, mission requirement, contract, or location.
6 This step is not required for reaccreditation connections that are already registered and all information is current.

 

Points of Contact

SIPRNet Support Center (SSC)
Unclassified email hostmaster@nic.mil
Phone (Commercial) 800-582-2567
Phone (DSN) 312-850-2713
Fax (Commercial) 614-692-3452
Fax (DSN) 312-850-3452
Website www.ssc.smil.mil

 

DISN Global Support Center (DGSC)
Unclassified Email DGSC@csd.disa.mil
Classified Email DGSC@cols.disa.smil.mil
Phone (Commercial) 800-554-DISN (3476), 614-692-4790
Phone (DSN) 312-850-4790

 

Primary POCs

Connection Approval Office (CAO)
Unclassified Connection Approval Office (UCAO)

disa.meade.ns.mbx.ucao@mail.mil
(NIPRNet)

or

disa.meade.ns.mbx.ucao@mail.smil.mil
(SIPRNet)
 

Classified Connection Approval Office (CCAO)

disa.meade.ns.mbx.ccao@mail.mil
(NIPRNet)

or

Disa.meade.ns.mbx.ccao@mail.smil.mil
(SIPRNet)
 

Phone (Commercial) 301-225-2900, 301-225-2901
Phone (DSN) 312-375-2900, 312-375-2901
Address Defense Information Systems Agency
ATTN: NSC1
PO Box 549
Fort Meade, MD20755-0549

 

U.S. Army

Army, Army National Guard, and Army Reserve organizations/offices with a requirement for NIPRNet service should contact US ARMY NETCOM, Ft Huachuca, AZ.

NETCOM ESTA, ATD
Phone (Commercial) 520-538-8029/8036
Phone (DSN) 312-879-8029/8036
Fax (Commercial) 520-538-0766


U.S. Air Force

For information on the AF NIPRNet provisioning process and AF DISN Subscription Service (DSS) locations, please contact:

AFCA DISN Command Lead
Phone (Commercial) 618-229-6186/5732
Phone (DSN) 312-779-6186/5732

 

U.S. Navy/U.S. Marine Corps

USN and USMC organizations/offices with a requirement for NIPRNet service should contact:

NCMO Office of Record, Pensacola, FL
Phone (Commercial) 850-452-7700
Phone (DSN) 312-992-7700

 

DISA Activities

Other DoD agencies should contact the DISA activity responsible for areas as indicated below:

GIG Areas 1, 2, and inter-GIG:

DISA CONUS Provisioning Center
Unclassified e-mail provtms@scott.disa.mil
Address PO Box 25860
Scott AFB, IL 62225-5860

 

Topology Diagram Requirements

Network Topology Diagram – this diagram depicts the network topology and security posture of the partner IS or network enclave that will be connecting to the DISN. The Network Topology Diagram should:

  • Be dated
  • Clearly delineate accreditation boundaries
  • Identify the CCSDs of all connections to the DISN
  • Identify equipment inventory (to include the most recent configuration including any enclave boundary firewalls, Intrusion Detection Systems (IDS), premise router, routers, switches, backside connections, Internet Protocol (IP) addresses, encryption devices, Cross Domain Solutions (CDS).
  • Other SIPRNet connections (access points) must be shown; the flow of information to, from, and through all connections, host IP addresses, and CCSD number, if known must be shown
  • Identify any other IA or IA-enabled products deployed in the enclave
  • Identify any connections to other systems/networks
  • Identification of other connected IS/enclaves must include:
    • The name of the organization that owns the IS/enclave
    • The connection type (e.g., wireless, dedicated point-to-point, etc.)
    • IP addresses for all devices within the enclave
    • The organization type (e.g., DoD, federal agency, contractor, etc.)
    • Identify Internetworking Operating System (IOS) version
    • Include the model number(s) and IP's of the devices on the diagram; diagram must show actual and planned interfaces to internal and external LANs or WANs (including backside connections)

     

    NOTE: It is important to note that in accordance with DoD and DISA guidance, firewalls, IDSs and Wireless-IDSs (where applicable) are required on all partner enclaves. Private IP addresses (non-routable) are not permitted on SIPRNet enclaves. Indicate and label all of the devices, features, or information; minimum diagram size: 8.5" x 11."

    The IA and IA-enabled products must be in the DoD UC Approved Products List and can be found at the DISA APLITS web page: https://aplits.disa.mil.

    NOTE: All topologies MUST include IP addresses and ranges. Click here to view an example of the NIPR/SIPR Enterprise Connection Division Topology.